|
|
|
|
|
|
|
|
|
|
|
|
This GP Large tent is constructed of mil spec
stop rip vinyl. The top seams
are heat weld sealed to provide
a leak resistant roof. The
main support is through a
2" poly webbing
grid attached to the tent
fabric; the grid is connected
to all the poles and supports
high stress areas.
This tent is equipped with aluminum support
poles and ridge beam assembly.
There are 10 - 5'-6" side poles, 4 - 6' door poles,
2 - 10' center
pole sets, and 1 - 17' long
ridge beam assembly.
This 18' x 52' x 12'
tent has a hip roof design with
two stovepipe shields to accommodate
the standard 4" heater pipe.
Each end wall is fitted with
2 environmental control
duct sleeves. The tent has one
screened doorway at each end.
The entire sidewall rolls and
ties in the up position for
flow through ventilation.
The complete tent includes an outer skin, 1
complete pole set, 30 (including
spares) 16" hard wood pins, 30 lines
with hard wood slips, and 2
bags: one for the tent and one
for the poles and accessories.
The shipping weight is approximately 400 pounds.
|
|
 |
GP Large Tent Charts
|
|
|
|
|
